Fiddes & Sons Supreme Wax Polish is formulated to offer excellent results on bare or sealed wood. Fiddes Supreme Wax Polish contains a unique, environmentally friendly blend of waxes that naturally enhances the beauty of your wood.
Quick drying and low aromatic
Fiddes and Sons Surpeme Wax Polish is the wax we apply to our oak beams and shelves to protect and seal the wood after the colour stain has been applied. It's great to maintain you oak products and keep it looking its best.
Please see below the colour wax we apply on top of each of our colour stains:
Light - Light
Antique Pine - Forest Brown
Medium Oak - Forest Brown
Walnut - Rugger Brown
Jacobean - Rugger Brown
Black - Rugger Brown
White - Light
Pale Grey - Light
Grey - Light
SPEC
Coats Needed: 1 (Further coats will depend the colour / enhance sheen level
Dry time: 3 minutes
Coverage: 16m² per litre (depending on substrate and method of application)
PREPARATION
Sand the wooden substrate in stages, working with a medium sandpaper (120 grit), through to a medium / fine grade (180 –220 grit). Always sand in the direction of the grain pattern where possible, ensuring the removal of any blemishes and glue residue prior to the application of Fiddes Supreme Wax. Take care to remove all traces of sanding dust and test the chosen Fiddes Supreme Wax shade on a similar substrate to verify the colour. A coat of Fiddes Shellac Sealer is recommended on open grained woods prior to application.
APPLICATION
Take a clean cotton cloth, sponge or brush and apply in the direction of the wood grain where possible. To obtain a uniform colour, always wipe evenly, blending the Supreme Wax over the whole surface area by exerting a small degree of pressure when applying by hand. Take care to lightly remove any excess Supreme Wax immediately with a separate, clean absorbent cloth, again following the direction of the grain pattern.
Leave to dry for around 3 minutes, and buff to finish with a soft cloth.
The application of additional coats will deepen the existing colour / shade and significantly enhance the resulting sheen level.
SPEC
Coats Needed: 1 (Further coats will depend the colour / enhance sheen level
Dry time: 3 minutes
Coverage: 16m² per litre (depending on substrate and method of application)
